Great Suggestion. I had tried some stiffer plastic and it didn't work
very well. Hopefully this will look better.
Peter Zaborski wrote:
> Roger,
>
> I just cut out a piece of a bicycle tube to the right shape and it
> works
> just fine. Only thing to be careful about is to make the holes for the
>
> screws considerably larger than the screws are so as to not have the
> gasket be "pulled" as you tighten. The rubber is much better than the
> original thin vinyl. I have not had anyproblems since I did this.
>
> Good luck!
>
> Peter Zaborski
> 76 TR6 (CF58310 UO)
> Calgary AB Canada
Roger Helman 71 TR6 CC67866L
Digimation Inc. http://deepthought.digimation.com/rogerh/
New Orleans La.
www.digimation.com
Voice. 504.468.7898
Fax. 504.468.5494
|