Jeff Nathanson wrote:
>
> Mark,
>
> You might try to cross reference them in the TRF catalogue. Locate
> the bolt
> in the bumber section and the part number of the bolt might be in the hardware
> section toward the end of volume 2. Anyway, almost all the of the bolts (of
> course there
> are exceptions) are UNF (UNited Fine) which can be found at any hardware
> store. But, just
> as important is the grade which in indicative of the strength. The higher
> the number = the
> stronger. Bumpers probably require grade 8.
>
Mark, Jeff, and all,
Actually, the rear center section uses 3/8" Unified National Fine (UNF)
STUDS with
nuts and washers. The corners use bolts. You can use bolts to put on
the center
section but it is much easier with the proper studs.
Regards
--
Chad Jester Seoul, KOREA
'74 TR6 CF15486UO
'65 Herald GB32939LCV
'6? Herald GB????????
|