[BOUNCE triumphs@Autox.Team.Net: global taboo body match
"/triumph.cs.utah.edu/i" at line 9]
Date: Wed, 18 Jun 1997 14:57:06 +0000
From: iani@tcp.co.uk
Subject: Re: FW:
GWP 200 is correct for MkIII, note that if you are going to use an
electric fan and not bother fitting the engine mounted one you can
use the 6 cyl water pump. The only difference being that the 6 cyl
isn't tapped to fit the fan.
> Date: Wed, 4 Jun 1997 10:17:06 +1200
> From: "Lindsay, Mike" <LindsayM@fish.govt.nz>
> Subject: Spit Mk III waterpump type ?
>
> Hi,
> [.....]
> So now my question.
> I have had the radiator recored and was concerned to find that after my
> by brief engine run that the engine was obviously losing water
> somewhere. Suspecting the worst I checked for water in sump oil (None)
> then noticed the next day that what I thought was a leak from the
> bottom radiator hose was in fact water being thrown out
> by the water pump. No problem. Replace water pump, but
> I cannot find a part listing for the water pump on a Mk III.
>
> The best information I have is that the water pump on all heralds and
> (Spitfires Mk 1 - Mk II) =3D GWP 200
>
> Spit Mk IV =3D GWP 128.
>
> I suspect that the Mk III should also be GWP 200 .
>
> Is there anyone out there that can confirm that for me?
> Is there anyone else out there that might have front and rear bumper(s)
> for a Mk III ?
>
> Cheers
> Mike
>
> Wellington
> New Zealand
Regards
Ian
|