I need the aluminum plugs that seal up each end of the oil galley on the TR 4
block. The machine shop had to distroy them to remove them to clean the
block. It seems to be a piece of threaded stock that is screwed into the
block and them cut off. It is some where between a 3/8" and 1/2" pipe
thread. I made a few phone calls to suppliers and they know of it but don't
have it. Does anyone have such a thing or know of a source?
Thanks,
Dean VanDeCarr
64 TR 4 Half way done (belongs to my 15 year old son)
73 TR 6 (should be done this summer)
|