Hi List,
I had a member of our club phone me last night with a problem, he
was trying to pull the hub on his TR4 (Girling axle) to deal with a faulty
oil seal, but with little success. The normal, bought in a motor factors
type puller was not man enough for the job. Is there an easy solution to
this problem or will he, as I suggested, have to take the axle to an
engineering workshop. He contacted Moss in the UK and they told him the
type of screw on puller made for this job could no longer be found, but
some have turned up at autojumbles. Any thoughts ??
John Gillis
1954 TR2 TS3618. October 1954 (ground up)
1964 Triumph 3TA 350cc (a little gem)
Trinity College
Dublin,
IRELAND.
|