I am trying to hook up my temperature and fuel gauges. The cute part about
the whole deal is that DPO cut the main wiring harness about 3 inches beyond
the tape. I have tracked down the wires from the temperature sending unit and
fuel sending unit. I can't seem to locate the wire that supplies the power to
the gauges. The wiring diagram in the Haynes manual shows a light green and
pink wire going into the voltage stabilizer, I assume that its a light green
and pink wire on the other side going to the gauges. Well I tried this and it
didn't work. The gauges work, I tested them. Does anyone know what amount of
voltage should be coming through the wire after the voltage stabilizer to the
gauges? I think if I can get a voltage amount I can track it down with the
multimeter. Thanks all.
----------
S. Ristroph
Augusta, GA
1972 Triumph Spitfire Mark IV
|