ralph,
how did you get a spit mkII factory workshop manual? I was under the
impression these were either never produced(?) or unavailable. I have
not seen them in vicky brit, moss or rimmer bros, and the catalog from
trf is apparently being printed (for almost a year now). might you know
of another one somewhere, or someplace I could buy one??
drooling in anticipation...
thanks
scott
p.s. sorry to spam the list, but mail to ralph bounced.
----------
From: Ralph Jannelli <rjannelli[SMTP:Ralph Jannelli
<rjannelli@aus-e.mp.campus.mci.net>]
Sent: Wednesday, February 26, 1997 9:59 AM
Subject: RE: Spit valve spring specs.
Dee - My Spitfire MKII factory workshop manual shows 117 lbs. Fitted =
load for the valve springs. I don't have data in hand on the 1500 by =
guess that it may be similar. Also the dual valve spring is a good idea,
=
but the cost is more that stated below, the springs themselves are not =
that much more but you must also buy new lower collars. Vicky Brit shows
=
the collars for $4.95 each x 8. The dual spring set is $32.95 vs. 24.95 =
for the single spring set.=20
|