Hello Jim, you wrote :
[snip]
>Anyone ever seen an S341?
>I'm using urethane bushings on my current project because the rubber
>bushings seem to shrink or just not hold up and have only replaced the
>bushings with the engine removed(which is fairly easy with a carpenter's
>clamp), but I would like to rent an S341 if some kind lister could oblige
>me.
>
>Jim Davis
>CF38690UO
>CF37325U
>
>
I haven't seen the actual tool, but the TR-250 manual from TRF shows a
picture of S341; it just looks like a long threaded rod with stamped
steel ends that conform to the shape of the rack mounting clamps.
Good luck finding that one. I suspect Steve B's pair of bent-nose
vice grips would work as well as any.
I remember using a big C-clamp and a drill bit to locate those clamps,
but now I can't tell you how I got them to stay put long enough to
tighten up the nuts on the bottom plates...dumb luck, maybe.
Best regards,
Tom Tweed
SW Ohio
'72 TRident 750 basket case
|