>I've been following the thread on the triple SU HS4 carb setup for six
>cylinder Triumphs with interest - unfortunately it appeared that the
>manifold made by Mr. Good wouldn't fit under a GT6 bonnet. I was
>considering the possibilities of casting my own (the casting's not bad
>but the thought of untold hours of sorting linkages, jets, etc. is a bit
>daunting), however...
With regards to fitting triple SU's to a GT6, anyone who has been in the TSSC
for a few years may well remember a member who cast his own manifolds to fit
triple SU's his GT6, this was done to create a 'look' similiar to an E-type.
There were plenty of photo's in the Courier(TSSC magazine), and if I remember
correctly he was even considering casting extras to sell. If you want I can
try and find out details.
Rich
Leicester Area Organisor - TSSC - For another year!!!
|