Trying to smog a TR 6. It is ok in all categories, except in CO, where it has
5.9 ppm(?), when the state will allow only 5.0. The timing is set to 6 deg
ATDC, and the mixture is leaned some. Suggestions and recomendations?
Thoughts and ideas?
There is an adjustment screw on the carbs after the jet which if opened will
allow O2 into the mixing area of the carbs. Should this be opened a little to
lower the CO? Would it lower the CO? What does this screw do?
Heeelp please!!!
Michael
Palo Alto, CA USA
Godafoss@AOL.com
|