Patrick McMullen wrote:
>
> Looks like a nice setup. And the price has come down considerably. In
> 1992 I looked into an Electronic Multi-Port system made by TWM using a
> Hal-Tech wiring harness for $5000.00. Naturally I bought three.....
> Actually I went the Weber route. But if the cost ever gets near the
> $2000 range, I feel that the injection system will be a better value as
> it will not require a trial and error set up as the side draughts do.
> (read xtra $$$) Plus no matter what temp, humidity or altitude, your in
> or at, the injection system will compensate without changing jets.
> My 40 DCOE's on a Canon intake with a TWM linkage, plus the extra jets
> needed to set up properly, plus the K&N air filters, Holley electric fuel
> pump and regulator, Ram Water Gaurd system in 1992 cost me around $1700.
> I did all the work so no labor charges were incured. Thats why I feel
> that if the price comes down arond 2 grand it would be a better value.
>
> Just my thoughts
>
> Pat in NC
Hi Patrick,
Thanks for the feedback. One thing that I need to change on the Web
page is that the price given is for selling just ONE unit (a special
order so-to-speak). Actually if there is enough interest expressed a
manufacuring run of 20 or more will be done than the price can drop into
the $1900 to $2000 range. I guess that wasn't made clear enough and I'll
have to add that to the Web page. Its tough manufacturing specialty
parts to such a small market so feedback from anyone who may be
interested is important.
Mark de Haas
TAc
|