At 03:04 PM 7/15/96 -0400, RBrown5149@aol.com wrote:
>I recently ordered a replacement water pump and pulley for my TR4A from
>Victoria British. The pump installed perfectly but when I bolt on the
>pulley, it lays up against the pump housing and will not rotate freely,
>almost as if there is a spacer missing but the diagrams show no such part. I
>contacted Victoria British and they do not have reports of the parts not
>fitting. They are sending me another pulley but in the meantime I wanted to
>know if anyone had any experience with this and if there is something else I
>should know about installing the pulley.
I have always seen replacement pumps with a press on pulley already
attached. Of course, the original pump pulley was bolt on. I am assuming
that the old pulley is not useable or damaged?
I do have some good used original type pulleys if this is of any help?
Otherwise, I would recommend getting the replacement pump with pulley (press
on) already fitted. Unless, VB can provide a correct pulley easily.
Regards,
Hal
Hal Rogers
H.D. Rogers & Sons
Import Auto Specialists
3418 Barksdale Blvd.
Bossier City LA 71112
(318) 742-3651 voice
(318) 742-5044 fax
Serving Auto Enthusiasts since 1959
|