In a message dated 96-05-30 09:40:04 EDT, you write:
>I am going to paint my '76 Spit. Probalbly using the K-mart spray can
>method.
>What tools do I use to prepare the surface for paint. I have some rust
>on the trunk lid. Do I need a special sander or just my $20.00 electric
>drill with some fancy attachment? Should I prime the entire car? What
color
>primer?
However you sand it down, etc., don't omit the essential step of (minimally)
metal-prepping before priming, and (preferably) conversion coating as well.
All in all, it's not a hard job, just a lot of surface to go over and over
and over and over, even on a Spit!
Good Luck
-Karl
|