To: | Ken Streeter <streeter@sanders.com> |
---|---|
Subject: | Re: TR6 - Half Shafts |
From: | Chad Jester <triumph@igc.net> |
Date: | Thu, 30 May 1996 13:06:22 -0700 |
Cc: | triumphs@autox.team.net |
Organization: | Internet Gateway Connections |
References: | <199605301453.KAA18913@hobbes.sanders.lockheed.com> |
Ken Streeter wrote: > > If anybody has actually read this far, I've got a question about this -- when > removing the hub, two of the six nyloc nuts were more firmly attached to the > hub mounting stud than the stud was to the trailing arm. How is one supposed > to tighten down a stud -- apparently I must be needing to buy another tool! > Ken, The appropriate tool, a stud installer, is available from Sears and I'm sure Snap-On carries one. If you want, I can probably look up the Sears part number for you. A small pair of vise-grip pliers works just as well, and I'm sure you have a set of these in you tool box ;0 Regards, Chad |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | Re: Dual SU HS2 Emission Control Valve <Pine.PCW.3.91.960529111021.4895D-100000@dos641.nysed.gov>, Dave Chu |
---|---|
Next by Date: | TR-6 Hulk in barn, Tom Tweed |
Previous by Thread: | Re[2]: TR6 - Half Shafts, jim.sudduth |
Next by Thread: | Cross Roads Auto?, MR STUART BOLLEN |
Indexes: | [Date] [Thread] [Top] [All Lists] |