In a message dated 96-03-23 08:38:41 EST, triumph@igc.net (Chad Jester)
writes:
>Could someone with a hardtop equipped TR-6 please measure the front header
>hold down bolts (the ones that pass through the windsheild frame to the
>front of the top) and email me the dimensions. The measurements of the rear
>hold down bolts would be helpful too. I seem to have lost my hardware while
>cleaning the garage. ;(
>
>
Chad:
The bolts that secure the hardtop to the windshield frame are 5/16 - 24 Bolts
2.5 inches long. Do not do what my car's PO did and try to force a 5/16-18
bolt in to the captive nut and break it off.
The bolts that secure the hardtop to the body just behind the doors are 5/16
- 24 Bolts 1 inche long. Also there is a special bracket attached by one of
the folding top mounting screws that is used with these bolts.
The bolts that secure the hardtop to the body at the rear are 1/4-28 Bolts
1.5 inches long.
Hope that answers your question.
Dave
|