On Mar Sat, 1996 6:03:56 AM, TR6Massey@aol.com wrote:
>To all TR6 Owners ( and TR4 IRS owners too)
>
>I replaced my trailing arm bushings with two piece polyurethane versions.
I
>removed the old ones using a large vice and a selection of socket
wrenches.
> I cut off the rubber flang from the trailing end to ease travel through
the
>hole in the arm. The istallation of the polyurethane bushings is trivial
in
>comparison to the original spec bushings. I highly recomend these.
Who did you get these from? I replaced mine several years ago with harder
bushings from TriumphTune, they were 1 piece. Worked great. These were
responsible for removing rear sag on my 6, and were so effective that I was
able to remove the spacers that I had under my rear springs.
Irv
74 TR6
CF22767U
|