I recently replaced both front wheel bearings and tracks on my '77
Spitfire 1500. The job went well except that the new felt grease seals
refused to go into their housing. They just seemed slightly too large
and eventually I destroyed them in the attempt to fit them. I
purchased replacements from Moss but these also would not fit. The
old seals fit and the seals from a spare spitfire hub I have fitted.
What am I doing wrong?
Any ideas?
Jonathan Miles
Dr J.E.Miles
School of Biological Sciences
University of Birmingham
Edgbaston
Birmingham
B15 2TT
0121-414-5884
j.e.miles@bham.ac.uk
|