August 29, 1995
Good Morning from Pittsburgh
1957 TR3
After replacing the speedometer cable the needle now remains steady
without swinging through an arc of 20-30 MPH. I always considered the
lower end of the arc the correct speed.
I also replaced the Tach cable. However, now the needle reaches about
2000 RPM and never goes beyond.
Does anyone have experience making adjustments on the tach ? The
internal workings have a small adjusting screw on the spring which
damps the needle and I planned on putting my electronic tach on the
engine, then fiddling with the screw to try and get a accurate reading.
Any warnings since I don't want to have to try and find and buy a new
tach.
Thanks
Paul g. Wiegman
Pittsburgh, PA
TR3 TS14551L
|