Ron
Thanks for the thoughtâ?¦but way beyond my technical capabilities. I have a
lead on one and still hoping others may speak up with an offer to sell one.
Jim
Sent from my iPad
> On Nov 10, 2021, at 4:01 PM, Ron Fraser <rfraser@bluefrog.com> wrote:
>
> Jim
> This is just a though.
> You might possibly TIG Braze a raised P onto the stamped P clamp.
> Not sure about this I'm not much of a welder.
>
> I was thinking maybe TIG a brass rod to the shape of the P - sand, file,
> sandblast to get the cast look.
>
> You would need to talk to an experienced TIG welder about this.
>
> Ron Fraser
>
> -----Original Message-----
> From: Tigers <tigers-bounces@autox.team.net> On Behalf Of James Lindner via
> Tigers
> Sent: Tuesday, November 09, 2021 3:28 PM
> To: tigers@autox.team.net
> Subject: [Tigers] WANTED: Original Battery Terminal Clamp(s)
>
> Hello
>
> I am looking for an original Battery Terminal Clamp. I need the Positive (P)
> clamp. I will take the N and P clamps, if necessary, although I have my
> original N clamp and strap. I have posted this same Wanted message to the
> CAT Forum and TEAE FB page without success. There are some aftermarket ones
> out there that are close but the P/N are stamped, as opposed to being cast.
>
> Any out there?
>
> Thanks
>
> Jim
>
> Sent from my iPad
> _______________________________________________
>
> tigers@autox.team.net
>
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/pipermail/tigers http://autox.team.net/archive
>
> Unsubscribe:
> http://autox.team.net/mailman/options/tigers/rfraser@bluefrog.com
>
>
_______________________________________________
tigers@autox.team.net
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/pipermail/tigers http://autox.team.net/archive
Unsubscribe: http://autox.team.net/mailman/options/tigers/mharc@autox.team.net
|