A little late with this response. Sorry, Gmail issues...
I visited with Benji at Griffin to discuss the new electric fan / radiator
combo. From their engineering drawings the fan adds another @ 2 1/2" on the
engine side of the radiator, My Tiger has less than an inch clearance
between the tip of the water pump and the radiator core. I suspect that's
about right, I might be able to finagle another half inch or so by horsing
the engine back, but no more (and I'm not gonna try it...).
So my impression is the electric fan won't fit with the engine driven water
pump installed. It MAY fit with an electric water pump, but that comes with
issues; the 6 bolt 289 uses a different pump than the 5 bolt 260 / 289. I
haven't looked into electric pumps so I don't know if they're available for
the 260.
Tom
'67 Mark 2
On Wed, Sep 3, 2014 at 9:27 PM, <genepadgett@comcast.net> wrote:
> I have the Griffin Radiator but no experience with the combo electric fan.
> At least one other Tiger owner and I had problems with the radiator
> fabrication. The two side flanges for mounting to the body were welded on
> wrong. They should be offset from the front of the radiator, but they
> offset them in the wrong direction. If you order one make them agree
> upfront to take it back at their cost if they send you one with this
> problem and send you one made correctly.
>
> Also, be sure you specify that you want one with a drain plug. It seems
> they have two different sets of drawings for their Tiger radiator. Not
> knowing the difference, I went with the Racing Version. That version does
> not have a drain plug... Did not know that until I went to install the
> radiator.
>
> Gene
>
> ----- Original Message -----
>
> From: "Brad Huff" <huffb@southslope.net>
> To: tigers@autox.team.net
> Sent: Wednesday, September 3, 2014 1:17:11 PM
> Subject: [Tigers] tiger radiator
>
> Gentlemen- Any thoughts on the Griffen CU-00179 aluminum radiator and fan
> combo cooling package? I have noticed a couple of scrapes on my existing
> radiator (recored years ago with a thicker core). The fan has kissed the
> radiator core and laid back the copper fins down to the tubes in a couple
> of
> spots. My thinking is that the Griffen radiator with its narrower core
> (1-1/2
> inches vs 2-1/2 on my existing radiator) and the narrow electric fan
> included
> with the combo might be better. I would then eliminate the stock mechanical
> fan and potentially gain back some room. Any thoughts? bBrad
> _______________________________________________
>
> tigers@autox.team.net
>
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe:
> http://autox.team.net/mailman/options/tigers/genepadgett@comcast.net
> _______________________________________________
>
> tigers@autox.team.net
>
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe:
> http://autox.team.net/mailman/options/tigers/tkparker1941@gmail.com
_______________________________________________
tigers@autox.team.net
Archive: http://www.team.net/archive
Unsubscribe: http://autox.team.net/mailman/options/tigers/mharc@autox.team.net
|