My guess is the TO Bearing isnt clipped on properly on both clips. The bearing
staying on the shaft, as it has no choice , if one of the two clips is off the
arm, the bearing is out of square, creating the described problems. While it
does work, just not properly.
Tony Lang (TtT)
>________________________________
> From: michael king
<michael.s.king@gmail.com>
>To: Tiger Talk List Tiger <tigers@autox.team.net>
>Sent: Sunday, February 3, 2013 2:27 AM
>Subject: [Tigers] Clutch activation
>
>To the knowledge bank,
>
>A friend has just got his Tiger on the road,
the hydraulics have been
>replaced, new clutch M/C and slave.
>
>When you
drive the car it is often very difficult to select a gear when
>stationary
when the engine is running, if the car is not running no issue
>at all. If you
let the car roll forward a little it selects nicely. There
>are no issues with
it when on the run, and if the car is switched off and
>you are just moving
the shifter.
>
>So linkage seems to be fine, no clutch slip, and no selection
issues.. just
>a problem when stationary... we suspect the arm is not
disengaging
>correctly... any thoughts or suggestions?
>
>--
>Regards
>
>Michael King
>_______________________________________________
>
>tigers@autox.team.net
>
>Donate: http://www.team.net/donate.html
>Archive:
>Forums: http://www.team.net/forums
>Unsubscribe:
http://autox.team.net/mailman/options/tigers/achd73@yahoo.com
>
>
>
>
>ce
_______________________________________________
tigers@autox.team.net
Archive: http://www.team.net/archive
Unsubscribe: http://autox.team.net/mailman/options/tigers/mharc@autox.team.net
|