I will actually be going through this exercise next weekend to install a fuel
cell. If I recall correctly, I first train the tanks and then loosen all the
hose clamps. I was able to slide the large rubber hoses inwards over the
cross-over tube. Then the cross over and these rubber hoses come out making
room for the curved tubes next. Finally the tanks come out.
Let me know if this makes sense.
Rob
Rob in Carmel, CA
1966 Mk1A Tiger
B382000262 LRXFE
JAL660245
Color Code 39: Carnival Red
TAC# 0519
On Sep 18, 2011, at 3:43 PM, Ron Fraser wrote:
> Andy
> Did you check the advance curve with you ignition tune up? I
> worked on an early Mustang and the distributor advance was hanging up
> causing poor idle adjustment and stalling.
>
> I don't know that there is a best order for pulling the tanks and
> tubes. Once you have the 4 rubber connectors loose the curved tubes should
> come right out.
>
> I would pump the tanks down with a clear view filter before the pump
> to see if it collects any particles. If there are no particles or few your
> probably OK. I would think most of the crude would collect in the main
> cross tube. I know I have some crude in my cross tube because I have a
> filter before my fuel pump and I see some crude in there. I have the cross
> tube on my to do list also.
>
> Ron Fraser
>
>
> -----Original Message-----
> From: tigers-bounces@autox.team.net [mailto:tigers-bounces@autox.team.net]
> On Behalf Of awtiger
> Sent: Monday, September 19, 2011 1:52 PM
> To: tigers@autox.team.net
> Subject: [Tigers] Gas tank question
>
>
> Hey, guys:
>
> I'm still having a stalling problem with my Tiger. I've performed a
> complete ignition tune up and have been through the Holley 465 carb. I've
> also replaced the fuel pump as well. In short, I'm now down to
> investigating further into the fuel system, which means checking for trash
> in the tanks. It's been a loooooooong time since I've pulled the gas tanks
> out of a Tiger and, frankly, I can't remember the proper order in which the
> apparatus is removed. Do the actual tanks come out first, followed by the
> curved pieces of pipe and then the balance tube, OR does the balance tube
> come out first, followed by the curved pipes and then the tanks? Can
> someone help jog my failing memory???
>
> Thanks,
> Andy Walker
> Edmond, OK
> B382001600LRXFE
> TAC #740
> _______________________________________________
>
> tigers@autox.team.net
>
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe:
> http://autox.team.net/mailman/options/tigers/rfraser@bluefrog.com
>
>
> No virus found in this incoming message.
> Checked by AVG - www.avg.com
> Version: 8.5.449 / Virus Database: 271.1.1/3901 - Release Date: 09/17/11
> 18:35:00
> _______________________________________________
>
> tigers@autox.team.net
>
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe: http://autox.team.net/mailman/options/tigers/crbernardino@mac.com
_______________________________________________
tigers@autox.team.net
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|