Hi Jerry,
That looks like a good solution but I would have recommended using a Pepsi
can.
John Logan
In a message dated 9/7/2011 5:07:38 P.M. Eastern Daylight Time,
JCMC2006@suddenlink.net writes:
Here is where the biggest groan will come - the aluminum that I used was a
piece of a Coke can!
If you try this make sure the inside of the valve cover is SURGICALLY
CLEAN
where the JB Weld goes!!!
Jerry Christopherson
9473187
_______________________________________________
tigers@autox.team.net
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|