The rubber hose should attach to a "tab" that is welded to the right side of
the rear axle housing (in the back) then a hard line goes from there to the
right brake assembly, and yes there is only one bleeder and it's on the
drivers side. Make sure the hard line from the rubber hose goes to the
bottom hole (the top hole goes to the drivers side) that way all the bubbles
from bleeding will go over to the drivers side to be expelled.
Hope this helps
Jerry Christopherson
9473187
-----Original Message-----
From: George Re
Sent: Wednesday, September 07, 2011 3:07 PM
To: Tigers
Subject: [Tigers] Rear Brake lines?
Hi again My question is. The steel brake line coming from the front of the
car going to the rear goes to one end of the Rubber brake hose, there is a
steel line going from the left wheel cylinder to the right wheel cylinder my
question is where does the other end of the rubber brake hose connect?. Do I
remove the bleeder from one of the wheel cylinders I do not remember I took
it apart many years ago and can not find and diagrams anywhere. Thanks Again
George Re
_______________________________________________
tigers@autox.team.net
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe:
http://autox.team.net/mailman/options/tigers/jcmc2006@suddenlink.net
_______________________________________________
tigers@autox.team.net
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|