Bob
The clip goes on the body 1st then push the center post of the clip
in flush with the clip to set it to the body. The center post in the clip
has to be out before you put the clip on the body. I'm not sure what the
correct hole size should be but you should not have to force anything to
much. If the hole needs to be a bit larger than what you have then make it
so.
The moulding will now snap over the clips, just line the moulding up with
all the clips and push the moulding over each clip.
The original moulding clips had some clips with studs and nuts to
anchor the moulding so it would not slide. These you would have to make
yourself since I don't believe they are available.
Ron Fraser
-----Original Message-----
From: tigers-bounces@autox.team.net [mailto:tigers-bounces@autox.team.net]
On Behalf Of Bob Dixon
Sent: Tuesday, August 30, 2011 12:35 PM
To: Tigers
Subject: [Tigers] Plastic side moulding clips
I was wondering if anyone had some tips on attaching the side moulding
with those little plastic clips from Rick? I am assuming an 1/8" hole
but that seems a little small. Do you put the clips on the body then
slide the moulding on, or do you put the clips in the moulding and then
tap the clips and moulding into place.
_______________________________________________
tigers@autox.team.net
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe:
http://autox.team.net/mailman/options/tigers/rfraser@bluefrog.com
No virus found in this incoming message.
Checked by AVG - www.avg.com
Version: 8.5.449 / Virus Database: 271.1.1/3867 - Release Date: 08/30/11
06:34:00
_______________________________________________
tigers@autox.team.net
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|