Good Dr.
I have a set of very ported aluminum Canfields with Ti valves, new
isky tool
room roller spring, Ti retainers, one of the ports needs welding
(intake) due
to weld that was not done right. Yours for a song if you want to
try to fix.
These might be big for your small Cube motor, but RPM can fix
that. They have
around 58cc chamber when last checked and made around 570hp
on a 331 with 12:1
CR and a healthy roller (I may even have a spare roller
and some shaft rockers
that you can get working with a few parts)
Sandy
----- Original Message ----
From: Larry Mayfield <drmayf@mayfco.com>
To:
"tigers@autox.team.net" <tigers@autox.team.net>
Sent: Wed, August 24, 2011
1:16:33 PM
Subject: [Tigers] Heads for the Sunbeam LSR Car
Seeking a pair of
used heads, either World Products Windsor Jr with 1.94 intake
and 1.6 exhaust
and 60 cc combusion chamber size. Complete heads. Or AFr 165
heads for the
Ford, with 1.90 intake and 1.60 exhaust with 58 cc combustion
chambers. Like
wise complete.
These are the only two I would like to have. I have surfed a
LOT ans had found
noting used.
Any of you have such?
mayf
Oh, Tiger
content... this motor will after hitting the salt go into my Tiger,
B947136.
-- ______________________________
drmayf
Worlds Fastest Sunbeam, period.
204.913 mph flying mile
210.779 mph exit speed
_______________________________________________
tigers@autox.team.net
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe:
http://autox.team.net/mailman/options/tigers/sganz@pacbell.net
_______________________________________________
tigers@autox.team.net
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|