The way I've done it is loosen all the clamps and wedge pieces wood around
the pipe where it passes through X trying to get even spacing on all side
of the pipe. Now tighten exhaust clamps and pipes should keep that even
spacing.
mark
In a message dated 2/27/2011 12:49:03 P.M. Eastern Standard Time,
brockctella@juno.com writes:
Put in new engine mounts due to sagging of old ones that allowed right
header to contact frame. Now this exhaust contacts the X frame where it
goes through the oval cutout. Any ideas on adjusting this? Thanks
____________________________________________________________
Kill Your Wrinkles
Mom Reveals Shocking $5 method for erasing wrinkles...Doctors
hate her
http://thirdpartyoffers.juno.com/TGL3141/4d6a8e4b14b774a40a4st03vuc
_______________________________________________
Tigers@autox.team.net
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe/Manage:
http://autox.team.net/mailman/options/tigers/coolvt@aol.com
_______________________________________________
Tigers@autox.team.net
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|