You can not slide this seal through from one end to the other that
is correct.
First you lay the seal across the top. You install the forward edge
of the seal into the track, 2 or 3 inches at a time, then push the rear edge
into the track then continue along. Use a screwdriver or plastic tool to
push the rear edge into the track. You might be able to get the seal into
the track with just your fingers, I don't recall right now if I could do
that but worth a try. Some rubber cement might be needed to hold the ends
in place.
If I remember correctly this can be a tedious job; you just need to
work it slowly.
Ron Fraser
-----Original Message-----
From: tigers-bounces@autox.team.net [mailto:tigers-bounces@autox.team.net]
On Behalf Of Gary
Sent: Sunday, January 02, 2011 11:22 AM
To: Tony Somebody
Cc: tigers@autox.team.net
Subject: Re: [Tigers] seal help
Tony,
I use a small flat tip screwdriver to install the rubber seal, instead of
trying to slide it. I put one edge of the rubber in the track and then pop
in the opposite edge and work my way along the track. There should also be
holes for a screw near each end of the seal to keep it from coming out, once
it is installed. I then trim it to length.
Gary
_______________________________________________
Tigers@autox.team.net
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe/Manage:
http://autox.team.net/mailman/options/tigers/rfraser@bluefrog.com
No virus found in this incoming message.
Checked by AVG - www.avg.com
Version: 8.5.449 / Virus Database: 271.1.1/3350 - Release Date: 01/02/11
07:34:00
_______________________________________________
Tigers@autox.team.net
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|