tigers
[Top] [All Lists]

Re: [Tigers] Help!

To: "'Alan Zeni'" <tigger@missiongranite.com>, "'tiger'"
Subject: Re: [Tigers] Help!
From: " Ron Fraser" <rfraser@bluefrog.com>
Date: Thu, 7 Oct 2010 13:27:37 -0400
Alan
        All the freeze plugs are smooth unless you have a Boss 302 block
which has threaded freeze plugs.

There is a small threaded plug in that area.   I believe it is a coolant
drain plug.

It should have a hex end on it so you can tighten it or maybe it needs some
sealant too.

Should be a 1/4" pipe thread but I'm not sure and I don't see a listing or a
part number for it.

That plug is shown in the Shop Manual; Section A, page 3, Fig 1.

Ron Fraser

-----Original Message-----
From: tigers-bounces@autox.team.net [mailto:tigers-bounces@autox.team.net]
On Behalf Of Alan Zeni
Sent: Thursday, October 07, 2010 11:21 AM
To: tiger
Subject: [Tigers] Help!


The machine shop is not answering his phone so I am turning to all of you
for some help.  I'm getting ready (or was) to fire up the 289.  I pressured
up the oil - no leaks.  Started to fill the cooling system and had a leak
out of the block.  It is on the drivers side, rear third.  It is small and
feels threaded.  Can anyone tell me if it is a freeze plug or a threaded
hole.  And if threaded, what size it is?

Thanks.
_______________________________________________
Tigers@autox.team.net
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe/Manage:
http://autox.team.net/mailman/options/tigers/rfraser@bluefrog.com

No virus found in this incoming message.
Checked by AVG - www.avg.com
Version: 8.5.448 / Virus Database: 271.1.1/3182 - Release Date: 10/07/10
06:34:00
_______________________________________________
Tigers@autox.team.net
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums

<Prev in Thread] Current Thread [Next in Thread>