John
The bolts are 1/2" UNF x 3 1/4"; UNF is compatible with SAE fine
thread but there are small differences. An SAE tap run through these
threads will cut metal.
Ron Fraser
-----Original Message-----
From: tigers-bounces@autox.team.net [mailto:tigers-bounces@autox.team.net]
On Behalf Of Carmods@aol.com
Sent: Tuesday, July 13, 2010 5:07 PM
To: tigers@autox.team.net
Subject: [Tigers] Crossmember Installation Headache
Jul 13, 2010 09:52:38 AM, Theo.Smit@dynastream.com wrote:
they're British fine thread which is almost but not quite the same as SAE:
Theo,
Are you sure those bolts are British Standard Fine Thread (BSF)?
What size are they?
John Logan
_______________________________________________
Tigers@autox.team.net
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe/Manage:
http://autox.team.net/mailman/options/tigers/rfraser@bluefrog.com
No virus found in this incoming message.
Checked by AVG - www.avg.com
Version: 8.5.441 / Virus Database: 271.1.1/2998 - Release Date: 07/13/10
06:36:00
_______________________________________________
Tigers@autox.team.net
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|