Stu's right. The cores under the bonnet release plate. The sides
do bulge
out when the MKIA 16 lb cap is used. The core is soft
metal and if you work
at it the sides will bend back. An old CAT
tech tip recommended putting in
reinforcing side straps.
I believe the large hole in the fire wall was used
for the steering
shaft of right hand drive cars. The stock large plug fits
it.
Dave (On Yahoo and loving it)
________________________________
From: kevin beck <kevinteresa.beck74@gmail.com>
To: Tigers@autox.team.net
Sent: Sunday, August 16, 2009 10:57:25 AM
Subject: [Tigers] venting
Removed
my outside vents last night to clean them out, its been so long
since my car
was on the road I can't remember how the venting works. I can
see the opening
in the middle of the two vents does air flow thru somewhere
or is the blower
needed? Also my heater core is bypassed now and my wood
dash is out of the
car, how hard is it to remove the core, and have the core
repaired? Or should
I fabricate some tubing to run out the existing holes?
Also my brake booster
was by passed and I need to get it rebuilt. there is a
good size hole behind
the booster in the firewall that is missing the rubber
plug does this have
anything to do with the booster or should I just put a
rubber plug in it? I
have a plug that fits, but it has a slit in it like
something went thru it at
one time or another. Thanks Kevin
_______________________________________________
Support Team.Net
http://www.team.net/donate.html
You are subscribed as djoh797014@yahoo.com
Tigers@autox.team.net
http://autox.team.net/mailman/listinfo/tigers
http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Tigers@autox.team.net
http://autox.team.net/mailman/listinfo/tigers
http://www.team.net/archive
|