Tony's note on the main bearings has me thinking I should check the
routing of the oil lines to the remote filter. If I got those backwards
then there wouldn't be a lot of flow because of the check valve in the
filter, right? I'm sure that I went over that several times as I was
doing the assembly but it won't hurt to check again.
I appreciate all the suggestions. I'll check into it all over the next
couple of days and see what is going on.
Theo
________________________________
From: Ronak, TP (Timothy) [mailto:Timothy.Ronak@akzonobel.com]
Sent: April 21, 2009 2:59 PM
To: Smit, Theo
Cc: Tiger News Group List
Subject: Teething
Theo,
The Cobra covers may be interfering at the breather or the
rockers may be hitting if you went to the roller rockers. The original
covers were intended for use with the stock stamped steel rockers. I
would start with this.
If the knock is internal ... sometimes hard to describe I might
look for Oil pump or Oil pan interference although I believe you had the
Canton pan on before.
I would use a stethoscope to narrow down the area of the knock
to diagnose the location or area of the sound.
Best Regards,
Tim Ronak
Services Consultant
Akzo Nobel Coatings, Inc.
23961 Via El Rocio
Mission Viejo, CA 92691
PH: 949-305-5393
Cell: 949-289-3357
FX: 425-955-6268
Email: timothy.ronak@crna.akzonobel.com
<mailto:timothy.ronak@crna.akzonobel.com>
Personal Email: timronak@cox.net <mailto:timronak@cox.net>
If you received this message in error please inform the sender
and delete the message.
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Tigers@autox.team.net
http://autox.team.net/mailman/listinfo/tigers
http://www.team.net/archive
|