tigers
[Top] [All Lists]

Re: [Tigers] Brake line routing

To: 'Tim Webster' <crabco@shaw.ca>, tigers@autox.team.net, rfraser@bluefrog.com
Subject: Re: [Tigers] Brake line routing
From: Tony Somebody <achd73@yahoo.com>
Date: Thu, 20 Nov 2008 21:43:47 -0800 (PST)
I think I would contact the vendors who make and sell brake and maybe fuel 
lines. My question would be if they are exact duplicate of orginal tooling or 
so close you dont have to spend hours rebending thier products. Im sure they 
will respond. Perhaps someone who has installed vendor prepared lines will 
speak up. Im interested in how well the lines fit as well for a down the road 
project.
TonytheTiger


--- On Thu, 11/20/08, Ron Fraser <rfraser@bluefrog.com> wrote:

> From: Ron Fraser <rfraser@bluefrog.com>
> Subject: Re: [Tigers] Brake line routing
> To: "'Tim Webster'" <crabco@shaw.ca>, tigers@autox.team.net
> Date: Thursday, November 20, 2008, 11:38 PM
> Tim
>       I believe the only diagram is in the Alpine parts list;
> publication
> # 6600992, non are very detailed.
> I think the fuel line and brake line both run down right
> side of the drive
> shaft tunnel and are held by clips.
> 
> I made new lines on my MK IA which should be similar; I can
> measure
> approximant lengths assuming I can still find the
> originals.  Which lines do
> you need.
> 
> Classic tube; I have seen their product and they appear to
> be excellent but
> I have not installed any.
> 
> Ron Fraser
> 
> 
> -----Original Message-----
> From: tigers-bounces@autox.team.net
> [mailto:tigers-bounces@autox.team.net]
> On Behalf Of Tim Webster
> Sent: Thursday, November 20, 2008 5:10 PM
> To: tigers@autox.team.net
> Subject: [Tigers] Brake line routing
> 
> 
> Hi,
> 
> I am having some problems figuring out how to correctly
> route my Mark 1
> brake hydraulic lines. Is there a resoruce somewhere that
> offers a schematic
> and description of the correct routing and mounting of
> these lines? I will
> be needing the same information for the fuel line. It would
> be handy to know
> the correct pipe lengths for each piece so I could have
> them made up
> 
> I had a pretty good look at the TU archives as well as
> those of this list
> but couldn't find much of help apart from a link to
> classictube.com who
> appear to sell prebent lines for the Tiger. Has anybody
> used their tube
> products for their Tiger?
> 
> Thanks,
> 
> Tim
> No virus found in this incoming message.
> Checked by AVG - http://www.avg.com
> Version: 8.0.175 / Virus Database: 270.9.8/1801 - Release
> Date: 11/20/2008
> 9:11 AM
> _______________________________________________
> Support Team.Net  http://www.team.net/donate.html
> 
> Tigers@autox.team.net
> http://autox.team.net/mailman/listinfo/tigers
> 
> http://www.team.net/archive
_______________________________________________
Support Team.Net  http://www.team.net/donate.html

Tigers@autox.team.net
http://autox.team.net/mailman/listinfo/tigers

http://www.team.net/archive

<Prev in Thread] Current Thread [Next in Thread>