tigers
[Top] [All Lists]

Re: [Tigers] Miloden Water Pumps

To: Dave Munroe <dave@munroe.ca>, "tigers@Autox.Team.Net"
Subject: Re: [Tigers] Miloden Water Pumps
From: "Teepen, Jere" <jteepen@usatoday.com>
Date: Tue, 26 Aug 2008 13:58:28 -0400
Dave:

The process for pressing the shaft back with the Milodon water pump is the
same a stock pump.  I did it to mine with no problem.

Jere

-----Original Message-----
From: tigers-bounces+jteepen=usatoday.com@autox.team.net
[mailto:tigers-bounces+jteepen=usatoday.com@autox.team.net] On Behalf Of Dave
Munroe
Sent: Tuesday, August 26, 2008 8:48 AM
To: tigers@Autox.Team.Net
Subject: Re: [Tigers] Miloden Water Pumps

Hey guys: (any "gal"  listers out there?)

Does anyone know if its possible to press the shaft back in a Miloden water
pump to gain clearance from the rad?

Since I installed an alloy rad approx  3/4 inch thicker than stock, and fitted
the original shroud, the fan blades are now buried in the shroud completely. I
understand for maximum effect the blades should be roughly 2/3 inside - 1/3
outside the shroud.
Two possible solutions: fit a shorter water pump (does one exist?) or shorten
the shroud, which would reduce the shroud's effectiveness.

I'm not sure which is the better of two bad choices: leave the fan buried ot
cut down the depth of the shroud?

Any suggestions?

Cheers,

Dave Munroe
_______________________________________________
Support Team.Net  http://www.team.net/donate.html


Tigers@autox.team.net
http://autox.team.net/mailman/listinfo/tigers

http://www.team.net/archive

<Prev in Thread] Current Thread [Next in Thread>