No, do not drill out the rivets
The lock comes out the back side.
Disassemble the push rod and the parts on the back side to remove the
tumbler.
It may be easiest to pull the whole lock assembly out of the car before you
try to remove the tumbler.
Ron Fraser
-----Original Message-----
From: tigers-bounces+rfraser=bluefrog.com@autox.team.net
[mailto:tigers-bounces+rfraser=bluefrog.com@autox.team.net] On Behalf Of
Brock Tella
Sent: Friday, August 22, 2008 3:22 PM
To: tigers@autox.team.net
Subject: [Tigers] Trunk lock
I searched everywhere but could not find the answer.
I ordered a new tumbler and keys but can not figure out how to replace it.
Do the rivets holding the chrome assembly to the metal latch have to be
drilled out? Any advice would be appreciated. Sent from my laptop located in
my kitchen. ____________________________________________________________
Find the medical school that's right for you. Click to request info today.
http://thirdpartyoffers.juno.com/TGL2141/fc/Ioyw6i3oIq84bnlHX3kZJkhxpmKArtV0
XdCnIqyvrwQKrkfMFomphA/
You are subscribed as rfraser@bluefrog.com
Tigers@autox.team.net http://autox.team.net/mailman/listinfo/tigers
http://www.team.net/archive
No virus found in this incoming message.
Checked by AVG - http://www.avg.com
Version: 8.0.138 / Virus Database: 270.6.6/1627 - Release Date: 8/22/2008
6:48 AM
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Tigers@autox.team.net
http://autox.team.net/mailman/listinfo/tigers
http://www.team.net/archive
|