tigers
[Top] [All Lists]

Re: [Tigers] Fulcrum pin bolts

To: <brockctella@juno.com>, <tigers@autox.team.net>
Subject: Re: [Tigers] Fulcrum pin bolts
From: "Smit, Theo" <Theo.Smit@dynastream.com>
Date: Fri, 11 Apr 2008 17:36:54 -0600
The fulcrum pin bolts are screwed into nut plates that are welded to the
inside of the crossmember. On mine one of the nut plates broke loose; I
drilled a 1/2" hole in the adjacent vertical edge of the crossmember,
which exposed a tang of the nut plate. I used some short fasteners to
hold the nut plate in position, and then rosette welded the plate back
to the crossmember. You could fabricate a new nut plate out of a piece
of steel and some quality 3/8 fine nuts, and then replace the original
nut plate...

Theo
_______________________________________________
Support Team.Net  http://www.team.net/donate.html


Tigers@autox.team.net
http://autox.team.net/mailman/listinfo/tigers

http://www.team.net/archive

<Prev in Thread] Current Thread [Next in Thread>