Did you tighten the mounts yet? If so, by loosening them some, it will allow
you a bit of "wiggle" room. Also - consider loosening the 3-bolts that
pass through the inner-fenders into the mounting bracket a little as well.
In addition, make sure you don't have the mounts backwards... That can
reposition the motor some.
----- Original Message -----
From: "Owain Lloyd" <owain.lloyd@gmail.com>
To: "Tiger List" <tigers@autox.team.net>
Sent: Wednesday, April 09, 2008 1:34 PM
Subject: [Tigers] engine mount alignment
> does anyone have any tricks for getting the engine into the right
> place to bolt up the mounts?
>
> i've just changed the mounts but the engine is sitting about 1/2" too
> far back for the bolts to go through the mount into the block.
> i don't seem to be able to budge it and there isn't and easy place to
> insert a bottle jack between the engine and the frame.
>
> thanks!
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Tigers@autox.team.net
http://autox.team.net/mailman/listinfo/tigers
http://www.team.net/archive
|