Mark,
I've made up a couple of test bulbs using 3 or 6 high-brightness white
LEDs, and this turned out to give significantly improved light with much
less heating of the instrument. I built a one-of back-board for the tach
that had an array of 6 LEDs and it was also very good. However, neither
of these solutions is easy, and the tach one specifically is not
'plug-in'. The LEDs also cost me about a buck each even in a significant
quantity.
The cool thing, though, is that it made the instruments bright enough
that a dimmer would be a useful option.
I put a page about it (at least the first round) up on TigersUnited.com,
http://www.tigersunited.com/techtips/SmitInstLED/SmitInstLED.asp
Since then I built up the ring-around-the-tach board (just as a
prototype) and I have pictures of it somewhere... I just have to find
it.
Theo
-----Original Message-----
From: tigers-bounces+theo.smit=dynastream.com@autox.team.net
[mailto:tigers-bounces+theo.smit=dynastream.com@autox.team.net] On
Behalf Of CoolVT@aol.com
Sent: April 4, 2008 1:51 PM
To: tigers@autox.team.net
Subject: [Tigers] Instrument illumination
Has anyone come up with an easy solution for improving the 2w that
come
with standard instrument bulbs? I searched through the archives and
found much
discussion on the subject, but didn't see to find a simple "plug in'
solution.
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Tigers@autox.team.net
http://autox.team.net/mailman/listinfo/tigers
http://www.team.net/archive
|