OK now that I am installing the 8842 edelbrock pump I now need the two
tube fittings that are 3/8 inch pipe thread that go into the water pump
for the bypass and the heater hose. Those of you that have done this
where did you get the fittings :-(
All of the ones I have seen are FAR too small for the heater hose. Any
help will be appreciated.
Best Regards,
Tim Ronak
Services Consultant
Akzo Nobel Coatings
23961 Via El Rocio
Mission Viejo, CA 92691
Bus: 949-305-5393
Fax: 425-955-6268
Cell: 949-289-3357
email: timothy.ronak@crna.akzonobel.com
Personal email: timronak@cox.net
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Tigers@autox.team.net
http://autox.team.net/mailman/listinfo/tigers
http://www.team.net/archive
|