tigers
[Top] [All Lists]

Re: [Tigers] engine mounting brackets

To: "Smit, Theo" <Theo.Smit@dynastream.com>
Subject: Re: [Tigers] engine mounting brackets
From: "Owain Lloyd" <owain.lloyd@gmail.com>
Date: Tue, 11 Mar 2008 13:41:40 +0000
ok thanks.  i think i'll suspend the engine on a chain, remove the
bracket and put a keysert in it.  i can then put new motor mounts in
at the same time.  the mount on that side seams to be all soft and
gooey.

On Tue, Mar 11, 2008 at 1:37 PM, Smit, Theo <Theo.Smit@dynastream.com> wrote:
> The cast steel part is threaded 3/8 UNF. The holes in the frame have
>  tubes set into them to keep the frame rails from getting crushed, so you
>  can't just drill out the mount and use the next larger bolt size. You
>  could use a Helicoil thread insert in the bracket.
>
>  Theo
_______________________________________________
Support Team.Net  http://www.team.net/donate.html


Tigers@autox.team.net
http://autox.team.net/mailman/listinfo/tigers

http://www.team.net/archive

<Prev in Thread] Current Thread [Next in Thread>