----- Original Message -----
From: "Tim Webster" <crabco@shaw.ca>
To: "David or Gary Franchi" <wwwdg@webtv.net>
Sent: Monday, January 07, 2008 4:23 PM
Subject: Re: [Tigers] Tigers Reverse Switch
> David,
>
> Thanks very much for your efforts re: Tiger back up lights switch. I was
> wondering what the hole was for and if it might have been related and
> haven't heard back from David Kee.
>
> What you did completely clarifies the matter and I see that the C5 part
> would be a problem to install.
>
> The C2 part can't be bought new so I will take your advice and check out
> the situation on eBay. I think your last suggestion about adapting
> something from an electrical store would be practical. On my boat I have a
> push switch that activates a pump. It almost looks like one of those would
> pop right in there as long as it had the right shaft length.
>
> I have been holding off reinstalling the 260 in order to get this done
> first. I think I'll go ahead and put the engine in now as it looks like
> this wouldn't be too hard to fit up afterwards.
>
> Thanks again and best regards,
>
> Tim Webster
>
>
> ----- Original Message -----
> From: "David or Gary Franchi" <wwwdg@webtv.net>
> To: <crabco@shaw.ca>; <tigers@autox.team.net>
> Sent: Sunday, January 06, 2008 2:27 PM
> Subject: Re: [Tigers] Tigers Reverse Switch
>
>
>> Link to the Tiger switch that works, sorry.
>> David
>> http://pic50.picturetrail.com/VOL439/2051017/12773325/296637083.jpg
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Tigers@autox.team.net
http://autox.team.net/mailman/listinfo/tigers
http://www.team.net/archive
|
