Hi Tony,
I did something similar but mounted the alternator to the driver's side
head (better set back for more room). I used a March adjustment rod
for the tensioner (not the bolt shown for fitting). Attached are two photos,
one with the alternator off to the side and one mounted at the head height.
I had to go with the later for clearances. I used the Edelbrock water pump
which worked very well.
Nice pictures!
Curtis
-------------- Original message ----------------------
From: Sandy Ganz <sganz@pacbell.net>
> I did some work on the Tiger motor.
>
> The mini-alternator (mine is a powermaster) bracket is pretty simple to make.
>I
> wanted it to be on 2 of the water pump bolts so I made a simple bracket to
>mount
> to the 2 top'is bolts of the pump. It is made out of 3/8" 6061-T6 aluminum
>plate
> and fits in a 2"x4" section. I have to make one spacer out of 3/4" x 1.125"
> round bar stock, and likely weld it to the back of the plate so I never have
>to
> worry about loosing it.
>
> Also just started a mounting bracket for a Canton-Mecca oil filter. This will
> mount in a similar way as to the old round one, but likely will have more
>room
> since it is a bit smaller. Canton makes a nice (but expensive) billet clamp
>for
> the square shaped filter housing. It will be welded to the part that bolts to
> the head. I need some more work but I have one not so good picture is also
>up.
>
> Here is the link to the pictures -
>
> http://www.flickr.com/photos/9422868@N02/sets/72157603069439008/detail/
>
> Hopefully the link doesn't get butchered too badly.
>
> Sandy
[demime 1.01d removed an attachment of type image/jpeg which had a name of Jan
26-05 011.jpg]
[demime 1.01d removed an attachment of type image/jpeg which had a name of Mar
26-05 015.jpg]
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Tigers@autox.team.net
http://autox.team.net/mailman/listinfo/tigers
http://www.team.net/archive
|