I used a pica typewriter (72 pts to the inch). I taped the label to a piece of
A size (8.5 x 11) paper. I fed the paper normally into the typewriter. I
centered in both axis where I wanted to put my type and I then proceeded to
type. It was an electric typewriter and it had just the correct amount of
force to the label to give it that correct "letter stamped" look.
Date: Mon, 13 Jun 2005 18:01:29 -0700
From: "Kathy and Erich Coiner" <kathy.coiner@gte.net>
Subject: Sunbeam LTD badge
I just bought one of these labels for the valve cover.
How do I go about getting the info printed on them?
Erich
|