Hi Charlie,
Near as I can figure out, it should run from the ignition switch, to the inside
of the tach, loop around once from the inside to the outside, and then to the
ignition coil. As shown in the link below.
http://members.shaw.ca/tsmit/tachmod/tachmod3.html
Best regards,
Theo
----- Original Message -----
From: Landcmitch@aol.com
Date: Sunday, February 27, 2005 2:05 pm
Subject: Tach Input Loop
> Tigers, Is there a preferred orientation of the signal input
> wire loop on
> the back of the tach, i.e. toward the inside or outside, or
> straight out?
>
>
> Charlie B9470574
|