Theo,
After rereading your question a couple of times I see the nuance with the
input shaft bearing retainers. You are talking about large Vs. small
retainer for the small input shaft transmission. I have both retainers and
see no reason why the McLeod unit would not fit either one. Considering the
way the slip on retainer attaches to the transmission and looking at the two
retainers (which appear to be practically identical except for OD of the
retainer flange) I sure can't see a problem. McLeod does not seem to
differentiate between the two in their catalog. The apps guy at McLeod
would probably be able to tell you for sure if you are still worried about
this.
Frank
> >...Since all the
> > hydraulic release bearings that are commercially available
> are made
> >to fit the larger input shaft bearing retainer, I'm looking
> at doing
> >machine work on either the release bearing flange or on the
> >bellhousing.
> > Theo
|