When I jacked the motor it slid right in as advertised.
Thanks to everyone, don't know what I would do without the "list."
As a last question,
What should I torque the bolts to?
Scott
-----Original Message-----
From: DJoh797014@aol.com [mailto:DJoh797014@aol.com]
Sent: Sat 6/5/2004 6:29 PM
To: Scott Hutchinson
Cc: tigers@autox.team.net
Subject: Re: Cross member
Simple. The weight of the engine spread the arms of the frame just
enough so the 4th bolt won't go in. Make sure the other 3 bolts
are loose. Place a 2x4 on the pan and jack the engine just enough
to take some weight off. Now you can insert the 4th bolt. Been there
done that.
Make sure you remove the jack before drive the car. Make a hellofva
noise if you don't.
Dave Johnson
|