The o ring is a replacement for the original goo. Pry out all the old goo
to make room for the oring.
If the white lettering has any brown or yellow spots on them, you can clean
them up with a small amount of rubbing compound. Use the fine stuff and
almost no pressure. Rub tooo hard and the lettering will disappear! But it
really makes them shine.
Erich
Gauges was my May project.
----- Original Message -----
From: "Robin Young" <robin02@mindspring.com>
To: "Tiger List" <tigers@autox.team.net>
Sent: Friday, July 11, 2003 7:35 PM
Subject: small gauge rebuild question
> I have disassembled my small gauges for interior clean-up as outlined on
> Tigers United. Everything is ready to reassemble but it seems there was a
> liquid gasket used to mount the glass to the case. Should this be done on
> reassembly or is the new o-ring between the bezel and glass all that is
> required?
>
> Thanks Robin Young B9471769
|