Rob, no this does not. The spindle and hub, with the mounting for the wheel,
remain in the same place. It is just the mounting of the rotor on the hub that
changes. In my case it is the mounting of the alum hat, then to the rotor that
changes.
The only change is the rotor position.
Larry
BlueGolfer@aol.com wrote:
> In a message dated 2/28/02 2:16:13 PM Eastern Standard Time,
> Veeseeoso@aol.com writes:
>
> > was reading the various entries about Doane's steering mods and, if I
> > remember correctly, the Wilwood upgrade kit I used does the exact same
> > thing...the new vented disc is installed outside the stock hub (hat). I
> > believe the Tiger is ready for a corrected Akerman angle.
> >
> One thing bothers me about this fix. The Tiger front wheels already stick out
> further than the rear wheels. This makes them stick out further, right?
>
> Rob
> Melbourne, FL
|