Lord Laifman wrote:
It is not all that difficult to remove the tranny alone, but it is very
> heavy, and a transmission jack is recommended (unless you are have a
> football team and a grease pit helping you.)
How does one do this? The shop manual says pull the engine and tranny as a
unit when you want to work on the clutch.
The tail end of the trans is buried in the hole thru the X brace
It appears there is not enough room to slide the trans rearward to get the
input shaft out of the bell housing.
Erich curious
> --
> Steve Laifman
> Editor
> http://www.TigersUnited.com
|