tigers
[Top] [All Lists]

Re: Lakewood Bellhousing??

To: "Bob Palmer" <rpalmer@ucsd.edu>, "Steve Laifman"
Subject: Re: Lakewood Bellhousing??
From: "Ken Mattice" <cat347@earthlink.net>
Date: Tue, 9 Oct 2001 10:23:47 -0700
I have one of the Chute Metal Products blankets that I intend to use with
the FI motor..Nice piece...very light and well made..Don't think they are
Kevlar..but rather somthing similar.
Regards,
Ken Mattice
----- Original Message -----
From: "Bob Palmer" <rpalmer@ucsd.edu>
To: "Steve Laifman" <SLaifman@SoCal.RR.com>; "Tim Morin" <tigert@ktc.com>
Cc: "Tiger list" <tigers@autox.team.net>
Sent: Sunday, October 07, 2001 2:25 PM
Subject: RE: Lakewood Bellhousing??


> Steve, Listers,
>
> Awhile back Jim Leach mentioned protective bellhousing blankets:
>
> "About two weeks back there was list talk about various scatter-shields
that
> will fit in a Tiger. Another option is to contact: CHUTE METAL RACE
PRODUCTS
> 20765 Plumber St. Chatsworth, CA. 91311 818-886-7396 This company will
knit
> you a Kevlar blanket that surrounds your bell housing and is NHRA
approved.
> This can be used with your existing aluminum bell housing and is much
> lighter than a steel or cast iron bell housing or traditional
> scatter-shield.
> Jim Leach, Seattle"
>
> This was found on the TigersUnited Website at:
>
>
> http://www.tigersunited.com/techtips/tt-gearbox.asp
>
>
> Bob

<Prev in Thread] Current Thread [Next in Thread>